Mini File

MINI FILES are designed to store A-, B- and C-size drawings. The drawings are attached to the appropriate size self-adhesive hangers and are then suspended on the curved rods within the file. The file is a clam shell design where both back and front sections hinge from the base.

There are two versions of the file which will stand alone on a table or on carts as shown.

MINI FILE OPERATION
To operate the file, the lid lifts and the door pulls forward. This exposes the curved rods which suspend the drawings. To remove a document, slide drawings back or forward until the desired document is at the center. Then press the release lever to allow the file to fully open for removal. To refile, reverse the above procedure.

MINI FILE CONSTRUCTION
The files are constructed of heavy guage steel, finished with powder coating. These ship assembled with the lids removed.

EASI FILE MINI FILING & STORAGE SYSTEMS

Models MF15 and MF25
MF15 - This is a single-wide unit designed to hold A- or B-size documents. The hanger is attached to the 11" or 12" edge.

Support Carts
MCU & MCL - Carts are offered for both of the above files. The MCU is the Upper Cart. The MCL is athe Lower Cart which will roll below the Upper Cart giving optimum space usage.

Easi File Corporation, 6 Wrigley Street, Irvine, CA 92618. Tel: 949-855-4121; Fax: 949-380-0561.