Product/Service

Fluid Film-Automotive

Source: Eureka Chemical Company U.S.A.
FLUID FILM AS & NAS in the handy spray can or pump bottle is quickly applied to tools, machine parts and less accessible areas of mechanical equipment.
For use on polished, machined, rough or rusty surfaces. FLUID FILM AS & NAS in the handy spray can or pump bottle is quickly applied to tools, machine parts and less accessible areas of mechanical equipment. FLUID FILM AS & NAS penetrates light rust to control corrosion of underlying metal surface and provides both rust inhibition and lubrication to rubbing or sliding metal parts, such as hinges, slides, tension spring seats and rods..

Suggested Automotive uses for FLUID FILM are:

  • All nuts, bolts and studs.
  • Mechanical parts such as:
      a. Brake levers
      b. Brake cable (emergency), speedometer cable.
      c. Hood and trunk mechanisms.
      d. Door hinges, opening and locking mechanisms.
      e. Window mechanisms.
  • Seat moving tracks and locks.
  • Tools
  • Inside hub caps.
  • Wheel lugs.
  • Preservation inside doors.
  • Uncovered springs.
  • Battery connections.
Trucks
  • Trailer attachments.
  • Truck bed bolts.
  • Blocks, turnbuckles.
  • Wire tie-downs
Directions: Spray on metal surfaces to be protected. Where applied to surfaces that may be touched or in contact with clothing, allow FLUID FILM AS & NAS to remain on the surface for a brief period, then wipe off with a soft cloth to remove excess.

Warning:FLUID FILM AS (AEROSOL) is extremely flammable. Contents under pressure. Keep from open flame. Do not store over 1200F. The NAS (NON-AEROSOL PUMP) is much safer to use in areas where ignition sources are present.

KEEP OUT OF REACH OF CHILDREN.

Eureka Chemical Company U.S.A., 234 Lawrence Avenue, South San Francisco, CA 94080. Tel: 650-761-3536; Fax: 650-589-1943.